HP — Removing the single board computer

Single Board Computer (SBC) Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • Phillips screwdriver Hardware • 6-32 x 1 ⁄ 4 ” Phillips pan head screws (x4) Removing the single board computer 1. Open the electronics bay. See “Opening the electronics bay” on page 171 2. Touch the metal plate of the electronics bay cover to discharge any static electricity. 3. Remove the controller board. See “Removing the controller board” on page 179 4. Disconnect the J2 power connector. See Figure 92. 5. Disconnect the SATA cable by pressing the tab in and pulling outwards. See Figure 92. Figure 92: J2 power and SATA connector locations Disconnect SATA connector Disconnect the J2 connector -182