HP — Installing the 24VDC power supply

Installing the 24VDC power supply 1. Align the 24VDC power supply with the top of the rear panel of the electronics bay and the tab to the right of the mounting location. See Figure 124. Figure 124: Align the 24VDC power supply 2. Using a Phillips screwdriver, reinstall the 2 mounting screws to the top of the rear panel. 3. Close the rear electronics bay panel. 4. Using a Phillips screwdriver, reinstall the 2 mounting screws. 5. Reconnect J3 1 through 4 connectors using a Phillips screwdriver. 6. Reconnect J1 on the 24VDC power supply. 7. Close the rear panel of the Electronics Bay. 8. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 3 mounting screws. 9.

Reinstall the electronics bay. See “Installing the electronics bay” on page 176 10. Reinstall the side panels. See “Installing the side panels” on page 164 11. Reinstall the top panel. See “Installing the top panel” on page 162 -204