HP — Installing the substrate sensor

Installing the substrate sensor 1. Align the substrate sensor with the mounting holes. 2. Using a 3 ⁄ 32 ” allen wrench, reinstall the 4 substrate sensor mounting screws. 3. Reconnect the substrate sensor wire to the head board. 4. Reinstall the wire tie around the head motor and wires. See Figure 153. Figure 153: Wire tie location Reinstall the wire tie around the head motor 5. Align the right side access panel with the mounting holes. 6. Using a 5 ⁄ 16 ” nut driver, reinstall the right side access panel mounting screws. 7. Reinstall the side panels. See “Installing the side panels” on page 164 8. Reinstall the top panel. See “Installing the top panel” on page 162 -222