HP — Removing the Y motor

Y Motor Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • 9 ⁄ 64 ” allen wrench. Hardware • 10-32 x 3 ⁄ 8 ” slotted screws (x11) • 8-32 x 1 ⁄ 2 ” socket head cap screws (x4) Removing the Y motor 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the upper electronics bay cover. See “Removing the upper elec- tronics bay cover” on page 173 4. Remove the left side access panel. See Figure 213. Figure 213: Left side access panel mounting screw locations Remove the 7 mounting screws. 5. Disconnect the Y motor cable by pressing in on the tab and pulling upward. See Figure 214. -260