SW2 SW5 SW6 Default Off Off Off Off Off Off Off Off Memory There are three types of memory contained on the controller board. • Dual Port RAM: The communication buffer between the controller board and the single board computer. Events (from the controller), commands (from the SBC), and motion control vertices (from the SBC) are passed through the P104 connector joining the two boards. • Flash Memory: Where the executable code resides. Battery backup RAM; Where the controller board stores the following system parameters: 1. Results of last power-on self test (POST) 2. Results of certain built-in diagnostic tests, if used 3.
Exception trace, which is a list of the most recent exception messages logged on the controller board 4.State information, which stores printer state when it is powered off (includes things like the type of gantry, whether material is loaded, the UDN, etc.). LEDs There are 11 LEDs located on the controller board. A grouping of three (D1- D3) are located on the lower left side. The other group of eight (D6-D13) are located on the upper right side. D1-D3 are lit when their associated voltage, as shown in table below, is present.
The 3.3 VDC supply is generated on the -12 Number (in white) Description Default 16-24 Unused Off Number (in white) Description Default 8-15 Unused Off Number (in white) Description 0 Run built-in self test (BIST) 1 Load Firmware (turn on when using SND- BIN.EXE) 2 Disable door latching 3 Unused 4 Don’t reset controller when in command is issued 5 Disable WatchDog timer 6 Enable use of dc commands 7 Unused