Installing the Y Drive Rod 1. Slide the Y drive rod through the Y belts and into position. 2. Align Y drive rod with the 6 mounting holes. 3. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 6 Y drive rod mounting screws. 4. Place the Y motor belt around the Y motor pulley. 5. Lift the Y motor until the Y belt is tight and use a 5 ⁄ 16 ” nut driver or stan- dard screwdriver to tighten the 4 Y motor mounting bracket mounting screws. 6. Align the foam insert over the mounting brackets. 7. Using a 5 ⁄ 16 ” nut driver or standard screwdriver reinstall the 4 foam retaining screws and washers. 8.
Align the head cooling fan mounting bracket and Use a 5 ⁄ 16 ” nut driver or standard screwdriver to reinstall the 2 mounting bracket screws. 9. Reconnect the head cooling fan. 10. Using a 5 ⁄ 16 ” nut driver or standard screwdriver reinstall the left side access panel. 11. Using a 5 ⁄ 16 ” nut driver or standard screwdriver reinstall the right side access panel. 12. Reinstall the Electronics Bay. See “Installing the electronics bay” on page 176 13. Reinstall the upper electronics bay cover. See “Installing the upper elec- tronics bay cover” on page 174 14. Place the left and right Y belts into the retaining clips. Do not tighten the retaining clips at this time. 15. Tension the Y belts.
See “Checking/Adjusting the Y-Drive Belt Tension” on page 384 16. Reinstall the left and right side access panels. 17. Reinstall the front panel. See “Installing the front panel” on page 168 18. Reinstall the Side panels. See “Installing the side panels” on page 164 19. Reinstall the top panel. See “Installing the top panel” on page 162 20. Reconnect the material bay cable, network cable and power cable. -280