Chamber Thermocouple Required Tools • 5 ⁄ 16 ” nut driver. • standard screwdriver. Removing the chamber thermocouple 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the upper electronics bay cover. See “Removing the upper elec- tronics bay cover” on page 173 4. Remove the electronics bay. See “Removing the electronics bay” on page 175 5. Push the strain relief clip out towards the front of the printer using a small standard screwdriver. See Figure 300. Figure 300: Strain relief clip location Push the strain relief tab towards the front of the printer to remove. 6.
Bend the tip of the thermocouple straight and slide out through the strain relief clip. 7. Remove the thermocouple. Installing the chamber thermocouple 1. Push the thermocouple through the mounting hole until it is 3/4” (19mm) through the other side. 2. Push the strain relief in to lock the thermocouple in place. 3. Bend the thermocouple over to the left. See Figure 301. -319