HP — Performing part based calibration for HP Designjet Color 3D with the HP Designjet Diagnostics Software

23. Measure and record the distance from the outside edge of circle H to the outside edge of circle I. See Figure 385 Figure 385: Measuring distances from outside edges of H and I 24. Measure and record the diameter of circle H along the center line between G and I. See Figure 386 Figure 386: Measuring diameter of circle H 25. Add the lengths derived from steps 22 and 23 (G-H and H-I) and then subtract the width of circle H derived from step 24. Record this total as “Rear” 26. Measure and record the distance from the outside edge of circle C to the outside edge of circle E. See Figure 387 -376