HP — Zero the Dial Indicator

Tensioning the X & Y Drive Belts CAUTION: The X & Y Drive Belt Tension must be checked and adjusted with the system and belts at room temperature (approximately 20 minutes to cool to room temperature). Zero the Dial Indicator 1. Insert the zero gauge block into the gauge. See Figure 394 2. Loosen the adjustment screw and slide the dial indicator assembly up or down to set the ‘zero’ reading: The large hand should be on 0 and the small hand on 5. 3. Tighten the adjustment screw (do not over tighten the screw) and recheck the reading. Reading should be same as step 2. 4. Remove the zero block gauge block from the fixture. Figure 394:

Tension gauge zero setting Adjustment screw Zero gauge block -381