HP — Establishing communication on a dynamic network:

Establishing network communication with the printer You will need to establish network communication between your workstation and printer before you can send files to be built. How you establish this communication with an IP address is dependent upon how your network and workstation are configured. If your network is configured for DHCP (Dynamic Host Configuration Protocol), your DHCP server will automatically assign a Dynamic IP address to your printer. This is the default setting for your HP Designjet printer and commonly used in large networks.

In some situations you may need to manually enter a Static IP address for your printer and record the IP address in the HP Designjet 3D Software Solution. Static IP addresses are frequently used for smaller networks. Follow the instructions below to configure your workstation and network. Establishing communication on a dynamic network: If you are on a dynamic network (or not sure of your network type) follow these steps to allow HP Designjet 3D Software Solution to find your printer and establish communication. 1. Connect a network cable between the printer and a network hub. 2. Make sure the printer is ON and determine the Unique Device Name (UDN) for your printer. A.

From Idle (or Ready to Build ), press Maintenance on the display panel. The display will show Maintenance and the software version. B. From the display panel press System . C. From the display panel press Set Network . The top window will display: Network Admin - Dynamic IP Address; UDN . D. The Unique Device Name (UDN) for your printer is listed here. This is preset at the factory and cannot be changed. 3. From your workstation, start the HP Designjet 3D Software Solution. 5. Click the Add from Network button in the lower right corner of the win- dow. 4. From the General tab, click the Manage 3D Printers button. 6.

A new window, Add 3D Printer , should list your printer in the main win- dow (identified by its UDN). Click on the printer in this window and enter a name and location in the lower portion of the window. 7. Click Add Printer and you are ready to print. Close the Add 3D Printer window. NOTE: If your printer is not displayed in the “Add 3D Printer” window, you are not using a dynamic network and you will need to set up a static network address. -26