Hard Drive Installation Checklist Replace the hard drive. Verify that all cables are connected correctly. Clean and vacuum the system. Power system up. After 10 minutes to 45 minutes, the LCD will display UPGRADE and Send Upgrade From Work Station along with the Dynamic IP Address of the system (the default system setting). NOTE: For convenience, the assigned IP address is visible in the display panel during this process. • If the system will be operating in a Dynamic environment, the UPGRADE can be loaded from the PC.
Use the Manage 3D Printers button in HP Designjet Software Solution to connect to the printer -Choose “Add from Network...” • If the system will be operating in a Static environment, choose Set Net- work... from the display panel and enter the appropriate network addresses. The customer should provide this information. After all the addresses have been edited, select Done . Use the Manage 3D Printers button in HP Designjet Software Solution to connect to the printer - Choose “Add Manually...” NOTE: The printer firmware must be downloaded before system operation can continue. Download the printer firmware using the most current version.
Download instructions for performing the download procedure are located on the firmware CD. Once download is complete, system will reach “Idle”. Load material. Run a small test part to ensure part quality is acceptable and that the system is operating properly. -420