HP — XY Table Assembly Installation Checklist

XY Table Assembly Installation Check- list If you have any questions before or during installation, do not hesitate to call your Customer Support provider.  Replace the XY table Assembly.  Verify that all electrical leads are connected correctly  Perform the XY Leveling procedure  Check/Adjust the X-Drive Belt tension  Check/Adjust the Y-Drive Belt tension  Manually move the table in both the X and Y direction to ensure it moves smoothly.  Clean and vacuum the system.  Power system up and verify that system homes correctly.  Load material.  Perform the Part Based Calibration procedure.  Perform the Z Calibration and XY Offset Calibration.

 Run a small test part to ensure part quality is acceptable and that the XY table is functioning correctly. -422