HP — Tera Term Commands

6. rt = repeat This command will tell the machine to repeat the previous command. The command line takes a repeat count, and flags whether or not to ignore errors. It also flags wether or not to show the command line of the command to be run. The command line consists of one or more commands separated by semicolons. The entire command line must be enclosed within double quotes. Each command within the command line consists of a name and its parameters. The command line is run until the iteration count is reached or an error occurs. For each iteration, each command within the command line is run in the order in which it appears.

• The command RT 1000 0 tm will help troubleshoot temperature issues in maintenance mode only. • The command RT 100 0 fh or RT 100 0 fz will help verify any X/Y/Z sensors that had issues before the repair are tested and operational. Parameters: Example: rt 20 1 tm Figure 443: Repeat -438 signed integer count This parameter specifies the number of times the command is to be run. signed integer ignoreErrors This parameter specifies whether errors should be ignored. A value of zero causes the test to stop when an is encountered A value of one causes the test to run for the full count even when errors occur.

string commandLine This parameter contains the command line of the command to be run enclosed within double quotes. A commandline includes the name of the command followed by it's parameters.