System firmware overview • Idle : If there is no part being built and no part in the build queue, the display will show that the printer is Idle . • Wait for Part or Start Part : If the printer is in Idle and the build queue is empty, you can set it to wait for a part. If the printer has a part in the build queue, you can press Start Part to start a build. • Building : If the printer is building a part, you can choose to pause, set the lights either ON or OFF, view the print time or material remaining and set the printer to auto power down. • Material: From this section you can load material, unload material or replace material. • Standby:
From this section you can set the printer to Standby mode. • Maintenance: From this section you can make changes to the Sys- tem, Setup or Machine . Figure 24: Display panel hierarchy Idle Standby Maintenance • Load Material • Pause • Unload Material • Replace Material • Lights Off • Show Time • Auto Power Down Machine • Set Network • Test Parts • Lights Always On • Select Language • Gantry • Head • Load Upgrade • Tips -38 Wait for Part /Start Part Mat erial Build ing Syste m Set up