7. Place the carrier on a flat stable surface. CAUTION: Do not push the material through the material guide back into the carrier, doing so can cause material to break or become tangled. 8. Open the carrier. 9. Rotate the spool to rewind the material, leaving 2 inches (50mm) remaining at the material guide. See Figure 29. Figure 29: Rewinding the material spool 10. Using a cutters, cut the excess 2 inches (50mm) of material from the material guide, leaving a blunt end. 11. Replace the material spool. 12. Close and latch the carrier. 13. Once the material carriers have been replaced press Load... 14.
You can select which carriers you want to load to the head by selecting Next Model or Next Support . When done selecting press Load Selected . 15. The printer will now load the selected material bays and prepare the other bays for automatic loading. After they are done loading and pre- paring, press Done... the display will show Wait for Part or Ready to Build . Material bay LEDs The table below will show the status indicated by the LEDs. On Material currently loaded to the head Off No carrier present Carrier present and ready to be loaded Blinking Carrier needs replacement (is empty or has an error) -49