Maintenance Startup kit tools The startup kit contains a set of tools used to help you maintain the printer. The following is a list of the tools contained in the startup kit. • Needle nose pliers • T-Handled allen wrench - 1/8 inch • T-Handled allen wrench - 7/64 inch • Gloves (Leather) • Cutters • Brush • Magnifier Preventive Maintenance Daily Empty the purge bucket Empty the purge bucket after each build has completed. Inspect the tip wipe assembly After each build you should inspect the tip wipe assembly to make sure there is no material build up. If there is material build up, clean the tip wipe assembly. Material build up on the tip wipe assembly can cause part quality issues.
See “Tip wipe assembly” on page 60. Inspect the tip shields After each build you should inspect the tip shields for damage or material build up. If there is material build up remove it as needed. If the material will not break free or there is damage to the tip shield, replace the tip shield. See “Tip shield replacement” on page 62. Remove debris buildup Remove all material buildup on the Z platform and around the lead screw. Failure to do so could cause the base to not be level or the Z platform to jam at its upper limit. Vacuum build chamber Vacuum the build chamber to remove all debris and purged material. Clean door Do not use ammonia based glass cleaner on the door.
It will damage the acrylic window. -59 CAUTION: ONLY use acrylic cleaner.