en Steam 11.3 Steam assistance 2. Press "Types of heating". 3. Press the type of heating that you want to use. a The corresponding default temperature appears in When you cook with steam assistance, the appliance introduces steam into the cooking compartment at vari- ous intervals. This gives your food a crispy crust and a shiny surface. Meat stays juicy, tender and only under- goes a minimum reduction in volume. the display. 11.4 After every steam operation Suitable types of heating with steam-assisted cooking Only certain types of heating are suitable for operation with steam-assisted cooking. You can switch on steam assistance for the following types of heating:
Ў 4D hot air Ў Top/bottom heating Ў Circulated air grilling Ў Keeping warm The remaining water is pumped back into the water tank after every operation with steam. Then empty and dry the water tank and the cooking compartment. Emptying the water tank WARNING ‒ Risk of burns! The water tank may heat up while the appliance is in operation. ▶ Wait until the water tank has cooled down from the previous operation. ▶ Remove the water tank from the tank recess. Setting steam-assisted cooking Requirement: The water tank has been filled. → "Filling the water tank", Page 18 1. Select the "Types of heating" operating mode. 2. Press a suitable type of heating. a The temperature is highlighted in white.
ATTENTION! Cleaning the water tank in the dishwasher will damage it. ▶ Do not clean the water tank in the dishwasher. ▶ Clean the water tank with a soft cloth and standard washing-up liquid. 3. Use the control ring to set the temperature. 4. Press "Added steam". 5. Use the control ring to set the steam setting. 1. Use to open the control panel. 2. Remove the water tank. 3. Carefully remove the lid of the water tank. 4. Empty the water tank, clean it with detergent and Steam setting Added steam 0 None 01 Low 02 Medium 03 High then rinse it thoroughly with clean water. 5. Dry all parts with a soft cloth. 6. Rub the seal on the lid until dry. 7. Leave the water tank to dry with the lid open. 8.
Place the lid on the water tank and push down on it. 9. Insert the water tank and close the control panel. Note: If the water tank runs dry during operation, a notification appears in the display. The appliance continues to operate without added steam. → "Filling the water tank", Page 18 a The appliance begins to heat up. a The time, how long the appliance has already been 6. Press to start. Drying the drip trough WARNING ‒ Risk of burns! The appliance becomes hot during operation. ▶ Allow the appliance to cool down before cleaning. Requirement: The cooking compartment has cooled down. 1. Open the appliance door. 2. Note: in operation, and the settings are shown in the dis- play. 7.
When the food is ready, press to switch the appli- ance off. 8. Empty the water tank and dry the cooking compart- The drip trough is underneath the cooking com- ment. → "After every steam operation", Page 20 Changing the steam setting You can change the steam setting at any time. 1. Press "Added steam". 2. Use the control ring to change the steam setting. a The change is applied immediately. Changing the temperature Once operation has started, you can change the tem- perature directly. ▶ Use the control ring to change the temperature. a The temperature is applied immediately. Changing the type of heating When you change the type of heating, the other set- tings will also be reset. 1.
Press to pause operation. sponge cloth and wipe it carefully. 20 Soak up the water in the drip trough wit