3. Mounting the light EN Select a flat and dry mounting surface, wipe the surface clean first, and then peel off the release liner from the base. Stick the base in the desired location and press it down firmly to make sure it is properly secured. Finally, atach the light to the magnetic base and adjust it to a suitable angle. Make sure it is firmly installed with the magnet, so as to avoid the risk of accidental dropping. Note: For accurate detection, it is recommended to face the light downwards when the base has been mounted over 1.9 m above the floor. Mounting point is over 1.9 m above the floor Facing downwards Mounting point is between 0.5–1.5 m above the floor Facing straight forward 03