omron — Outer Arms

Chapter 9: Environmental Concerns The Hornet 565 protects the operating environment in the following ways: l High level of surface coating adhesion prevents erosion during cleaning. l Lubricants are contained within multiple seals. l Ball joints and springs/horseshoes are designed for minimal particulate generation. l The theta drive shaft is designed for minimal particulate generation. l All moving parts are designed so that small parts are encased within larger assemblies, and are unable to contaminate the work environment. Robot Base and Components The aluminum robot base and cover are coated with a white ETFE (Teflon), which will not flake off with repeated high-pressure washings.

This coating is resistant to caustic and chlor- inated agents, has strong adherence to the metal base to resist impact, and has a smooth finish that is easy to clean. The gearboxes are sealed internally, and sealed externally by a lip seal that is designed to meet IP65 rating. All base seal materials are designed to be compatible with caustic agents and common indus- trial cleaning procedures. CAUTION: Like most seals, it is possible to prematurely destroy these seals by deliberate, direct, excessive spraying of water-based agents into the sealing materials. Inner Arms The inner arms are electroless nickel-plated aluminum.

The assemblies are resistant to some caustic cleaning agents at room temperature, as well as to chipping. The inner arms are sealed at the robot base with a rotary V-ring seal. The inner arms are designed to meet IP65 rating. Ball Joints The ball studs are stainless steel. The hemispherical plastic inserts are resistant to caustic agents. The inserts generally produce few wear particulates. The material used in the inserts is FDA-compliant. Lubrication of the ball joints is not needed. Refer to Chemical Compatibility on page 100. Contact Omron Adept Technologies, Inc. for more information. Outer Arms The outer arms are a composite assembly of carbon fiber and black anodized aluminum.

The interior volume of the carbon fiber tube is sealed with an internal and external continuous epoxy bond. The horseshoe-retaining pins are press-fit into the outer-arm ends with a slight interference. The outer arms may be cleaned either with wash-down in place on the robot, or removal and tank cleaning. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 152 of 156