Chapter 4: System Installation 4.4 ACE Software User-supplied PC The user loads the ACE software onto the PC and connects it to the eAIB via an Ethernet cable. Depending on the other equipment in the system, there may be an Ethernet switch between the two. Installing ACE Software The ACE disk will display a ReadMe file when inserted in your PC. This contains hardware and software requirements for running ACE software. You install ACE from the Software disk. ACE needs Microsoft .NET Framework. The ACE Setup Wizard scans your PC for .NET, and installs it automatically if it is not already installed. 1. Insert the disk into the disk drive of your PC.
If Autoplay is enabled, the software disk menu is displayed. If Autoplay is disabled, you will need to manually start the disk. NOTE: The online document that describes the installation process opens in the back- ground when you select one of software installation steps below. 2. Especially if you are upgrading your ACE software installation: from the ACE software disk menu, click Read Important Information. 3. From the ACE software disk menu, select: Install the ACE Software The ACE Setup wizard opens. 4. Follow the online instructions as you step through the installation process. 5. When the installation is complete, click Finish. 6.
After closing the ACE Setup wizard, click Exit on the disk menu to close the menu. NOTE : You will have to restart the PC after installing ACE software. Hornet 565 Robot User's Guide, 14608-000 Rev C Page 45 of 156