System Error Codes NOTE: Applicable for 111 only: The printer has a MROM module and it is not possible to perform a firmware upgrade, and in fact not required as the printer already has the latest version. 01:10 Cause Solution Electronics Module failure. Replace the Electronics Module Electronics Module on page 109 . 01:12 Cause Solution Electronics Module failed during the firmware upgrade OR the Electronics Module failed during initialization. Try the following: ● If the Electronics Module failed during the firmware upgrade, first perform an emergency firmware upgrade ( Emergency Firmware Upgrade on page 33 ).
● If an emergency firmware upgrade is NOT possible or it didn’t work, replace the Electronics Module Electronics Module on page 109 . 02:10 Cause Solution Carriage failure. Replace the Carriage Assembly Carriage Assembly (Applicability: 70, 100+, 110+, 111) on page 123 . 04:13 Cause Solution Generic Firmware Error (Network Card). Unplug the power cable from the printer and wait a few seconds. Plug in the power cable again and check if the Error Code has disappeared. If the error code continues, refer to the Jetdirect Card Service Manual and Service Notes. 08:11 Cause Solution Front Panel cannot be detected. Try the following:
● Check the connections and cables of the Font Panel, check they have not been damaged and are correctly connected, disconnect and reconnect the front panel. ● Replace the Front Panel if the problem persists Front Panel on page 117 . 10 Chapter 2 System Error Codes ENWW