Controlling the Page Format Page Size Page Size This chapter explains how to make sure that the plotter prints your plot in the page size you want. Media Terminology Page size Margin Plotting area Inked area 0023 Page size This can be specified from the front panel or in the software, where it may be called ‘‘Page Size”, ‘‘Media Size”, ‘‘Paper Size” etc., and where the options include, for example, ISO A3, ANSI Letter, Architectural E and Custom. If the drivers setting is ‘‘default”, the front panel setting is used. Any other software setting overrides the front panel setting, unless the latter is Inked area and you are sending a PostScript file:
in this case the front panel setting takes precedence. When using the AutoCAD driver the “User Size” is the plotting area. Margins These are specific to the plotter and are normally 17 mm on the leading and trailing edges and 5 mm on the sides. The 17 mm can be adjusted for roll media, as explained on page 11-3. Plotting area This is the page size minus the margins. For a table showing the plotting areas for standard media sizes, see page 11-6. This is the smallest rectangle that contains the entire drawing, while maintaining its relative dimensions. 4-2