Controlling the Page Format Adjusting the Margins (Roll Media Only) Adjusting the Margins (Roll Media Only) Besides nesting and setting the page size, you can also change the margin settings and expand the plotting area of the page, therefore reducing the amount of media waste. The two side margins are 5.0 mm. The automatic setting of the plotter’s margins is 17 mm on the leading and trailing edges of the media. By reducing the margins to 10 mm on the leading and trailing edges of the media, you can use 14 mm more plotting area along that axis. The adjustment is available in the front panel. Page format Smaller Margins Normal Margins Margins Trailing edge Full menu mode Default:
Normal Affects next plot 17.0 mm 10 mm 5.0 mm 5.0 mm 5.0 mm 17.0 mm 10 mm Leading edge 5 mm = 0.2 in 10 mm = 0.4 in 17 mm = 0.67 in 0024 Margins and Automatic Cutting IMPORTANT When Margins is set to Smaller, the plotter waits for the plot to dry and the next plot to begin plotting before cutting the plot from the roll. If you press Form Feed and Cut , the plotter immediately cuts off the current plot. When the next plot begins, the plotter cuts again to give this plot the narrow margin. 4-6