HP — HP DESIGNJET 700/750C PLUS PLOTTER - USER'S GUIDE, C4705-60021

Managing Your Plots Avoiding Media Waste by Nesting Pages (Roll Media Only) To Turn Nesting On or Off and Choose the Nesting Method Queueing & Nesting Nest All menu modes Default: Off What Happens to Nesting if you Turn Queueing Off? Turning queueing off does not turn nesting off for pages already in the queue. The plotter prints all the pages in the queue before accepting any more files. As soon as you turn queueing off, the nesting setting also changes to off . When queueing is turned on again, the plotter restores nesting to its previous setting. How Long Does the Plotter Wait for Another File?

So that the plotter can make the best nest possible, it waits after a file has been received to check if a subsequent page will nest with it or with pages already in the queue. This waiting period is the nest wait time. The factory default nest wait time is two minutes. This means that the plotter waits for up to two minutes after the last file is received before plotting the final nest. You can change this waiting time using the front panel menu (as shown opposite). The available range is 1 minute through to 99 minutes. Queueing & Nesting Nest Optimal In order Nest wait All menu modes Default: 2 minutes 6-12 Nest Setting Selected Plotter’s Response Off The plotter will not nest pages.

Optimal Choose this if you want to use the least amount of media. The plotter will search all through the queue for suitable pages. It will nest the pages according to an algorithm that, for most combinations of page sizes, saves the most media. The resulting nesting pattern may still vary, depending on the size of the first page. In order Choose this if the speed with which you receive your plots is most important. The plotter will try to nest pages in their queue sequence. If it comes across an incompatible page, it will stop searching and print any nest it has already created.