Troubleshooting Solving Miscellaneous Problems If the Plotter Waits Too Long to Plot a Nest Change the Nest wait setting. See page 6-12. If the Plotter Performs the Cartridge Alignment Routine Unexpectedly This is a normal plotter operation. The plotter will align the cartridge(s) every time you replace, or even reseat, a cartridge, whether or not it is new. If the Bail (Black Metal Bar) Does Not Lower All the Way If the the bail (the black metal bar just inside the plotter’s window) will not lower all the way, check for obstructions underneath it. Make sure the cutting carriage is pushed all the way to the right. 9-24