HP — HP DESIGNJET 700/750C PLUS PLOTTER - USER'S GUIDE, C4705-60021

Reference Interface Specifications Interface Specifications Below are the parallel and serial interface specifications. REFERENCE 11 11-7 Parallel (Bi-Tronics/Centronics) Interface The connector on the plotter is 36-pin female. Most existing parallel cables support Bi-Tronics communication, but for use with this plotter, the cable must meet the specification in this table. Pin Wire/Signal Name Source 1 Strobe computer 2 ... 9 D0 ... D7 (data lines) both 10 Ack plotter 11 Busy plotter 12 PError plotter 13 Select (SelectOut) plotter 14 AutoFd computer 16 GND 19 ...

30 GND 31 Init computer 32 Fault plotter 36 SelectIn computer Serial (RS-232-C) Interface The connector on the plotter is 25 -pin female. The plotter is configured as DTE (data terminal equipment). Data is transmitted on Pin 2 and received on Pin 3. Pin Wire/Signal Name Source 1 Protective Ground 2 Transmitted Data DTE 3 Received Data DCE 4 Request to Send DTE 6 Data Set Ready DCE 7 Signal Ground 20 Data Terminal Ready DTE