Setting Up the Plotter Fast Track Fast Track If You Meet All the Following Requirements: You want English as the language of the front-panel display and of the plotter’s internal plots. You are experienced at installing printers or plotters. You don’t want to add extra memory. 700 For the HP DesignJet 700: You are going to use roll media. 750C Plus For the HP DesignJet 750C Plus: You are going to use roll media and print in color. You know whether to connect the plotter directly to your computer or to a network and whether to use the parallel or serial interface, and you already have the right cable.
(Serial interface users) Your computer’s RS-232-C settings are 9600 baud, no parity, 8 data bits and 1 stop bit. ... Just Do the Following Six Steps and Skip the Rest of This Chapter. 1 Connect the power cord and switch on. 2 Load the roll of media supplied, following the instructions on the label inside the plotter’s roll cover. Watch the front-panel display for further instructions. 3 Press Access Cartridge(s) and open the plotter window. 700 For the HP DesignJet 700: Load the black print-cartridge into the carriage on the left side of the plotter. Don’t forget to remove the tape from the cartridge. 750C Plus For the HP DesignJet 750C Plus:
Load the four color print-cartridges into the carriage on the left side of the plotter. Don’t forget to remove the tape from the cartridges. Continued... 1-2