Setting Up the Plotter Task 8: (Serial Interface Users Only) Configure the Interface Task 8: Configure the Interface (Serial Interface Users Only) The following table shows the settings available for the plotter’s serial interface parameters, the factory defaults and the most likely requirements for different computers. SETUP 1 The settings on the plotter must match those of the computer and software sending the data. Use their documentation to find the requirements. If in doubt, try with the above suggestions. If the plotter’s defaults already match the requirements, then you can skip the rest of this task.
1-29 Serial (RS-232-C) Settings Parameter Available settings Likely requirement for ... PC Macintosh Unix Baud rate 1200 2400 4800 9600 19200 38400 9600 (2) 9600 Parity(1) None Even Odd None (2) None Italics = factory default (1) Parity of None = 8 data bits, 1 stop bit Parity of Even or Odd = 7 data bits, 1 stop bit (2) Consult your software documentation.