Setting Up the Plotter Task 8: (Serial Interface Users Only) Configure the Interface 3 Configure the serial interface to match your software configuration. CONFIG A This example changes the configuration to 19200 Baud and Even parity. Baudrate=9600 Press Enter BAUDRATE 9600* SETUP 1 Press ↑ BAUDRATE 19200 Press Enter Baudrate=19200 CONFIG A Press ↓ parity=None(0) CONFIG A Press Enter none(0)* PARITY Press ↓ PARITY Even Press Enter CONFIG A Parity=Even RS–232–C Press Previous until you return to .. . Config=Factory 1-33