Working With Media and Cartridge(s) Choosing Media Combinations of Media Type and Print Quality The table below shows that some combinations of media type and print quality are not recommended. 700 750C Plus 750C Plus 750C Plus 750C Plus IMPORTANT If you are using an add-on a third-party Raster Image Processor (RIP), in order to create additional print modes on your plotter, then the above table may not apply. In this case, consult your RIP vendor for advice on the best settings for your re- quirements. A clue as to whether you are using a RIP or not is the message on the plotter’s front panel while it is printing.
If the message “STATUS / Printing (spe- cial)” appears, then you are using a RIP. If the message “STATUS / Printing” appears, then you are probably not using a RIP. 3-6 Media Type on the Front Panel Display Print Quality (Set Either on the Front Panel or In the Software) Fast Normal Best Opaque bond OK OK OK Translucent bond OK OK OK Translucent bond OK in monochrome only OK in monochrome only OK in monochrome only Natural tracing paper OK OK OK Vellum OK OK OK Coated paper OK OK OK Heavy coated paper OK OK OK Matte film OK OK OK Clear film OK OK OK High-gloss photo Not recommended OK OK Semi-gloss photo Not recommended OK OK High-gloss film Not recommended OK OK