Working With Media and Cartridge(s) Loading Media 8 Push the endcap back in, making sure that the tabs are flush against the ends of the roll. Push it far enough to be firm, but do not use excessive force as this may result in broken tabs. B 0016 9 Insert the spindle so that the media stop (A) is to the right and the endcap (B) to the left. Push in firmly on both ends. Make sure the media remains flush against the media stop. MEDIA AND CARTRIDGES 3 B A A Media path 0017 The media should wind up from behind the roll. 1837 10 Check the leading edge as it unwinds from the spool. If it is uneven, trim it as explained in step 11. Otherwise go to step 12. 3-13