Removal and Installation EMC Covers Removal WARNING Switch off the Printer and remove the Power Cord. NOTE Refer to the table on Page 8-4 for information on screw types. NOTE The EMC Cover is composed of three parts; Top, Lower Left and Lower Right. Procedures below describe removal of the EMC Covers as; one assembly, the Top only, the Lower Right only. The procedure you select depends on the part you want to access. EMC Covers as one assembly 1. Remove the Top Cover - Refer to Page 8-5 . 2. Remove the Back Cover - Refer to Page 8-23 . 3. Remove Right Rear Cover - Refer to Page 8-16 . 4. Remove Left Rear Cover - Refer to Page 8-15 . 5. Remove Electronics Module - Refer to Page 8-97 . 6.
Disconnect connector from Ink Leak Detector and remove 1 T-15 screw ( Type B ) to remove Ink Leak Detector cable clamp. NOTE The Ink Leak Detector is NOT present in the DesignJet 5500 Series and in some DesignJet 5000 Series printers. 8-32 HP DesignJet 5000 and 5500 Series Printers Service Manual