Main motor 1. Remove the following assemblies. ● Scanner assembly. See Scanner assembly on page 67 . ● Formatter. See Formatter on page 94 . ● Left cover. See Device side covers on page 82 . ● Rear cover and fuser cover. See Rear cover and fuser cover on page 86 . ● Print cartridge door. See Print-cartridge door on page 85 . ● Front cover. See Front cover on page 88 . ● Scanner support frame. See Scanner support frame on page 95 . ● ECU. See Engine controller unit on page 98 . ● Laser/scanner assembly. See Laser/scanner assembly on page 102 . 2. Disconnect the motor wire-harness connector (callout 1) and remove one screw (callout 2).
Figure 6-63 Remove the main motor (1 of 2) ENWW Removal and replacement strategy 103