Transfer roller 1. Open the rear door. 2. Release the retainer clip and then rotate it until the pin on the clip aligns with the slot in the mounting bracket. Figure 1-6 Remove the transfer roller (1 of 3) 3. Remove the clip. Repeat these steps for the remaining retainer clip (located at the opposite end of the roller shaft). TIP: One of the clips (callout 1) is made from a black conductive plastic. Make sure that the clips are reinstalled on correct the end of the transfer roller. Figure 1-7 Remove the transfer roller (2 of 3) 1 12 Chapter 1 Removal and replacement ENWW