HP OmniBook 900 Troubleshooting and Diagnostics 3-25 System Devices Menu Default PS/2 Pointing Devices Sets whether internal pointing devices are automatically Auto disabled when an external PS/2 pointing device is detected, or whether both internal and external devices are active. This is required for the scroll wheel on a PS/2 mouse to function. Internal Pointing Devices Enables one or both built-in PS/2 devices. Both External Fn Key Sets whether left-CTRL + left-ALT on an external keyboard is Enabled interpreted as the Fn key. IDE Controller Enables the primary (hard drive) and secondary (optional CD- Both ROM drive) controllers. FDD Controller Enables the floppy drive.
Enabled Serial Port Sets how the serial port is configured by the BIOS (specified Enabled or automatic). Base I/O address Sets the I/O address and interrupt. 3F8h, IRQ4 Infrared Port Sets how the infrared port is configured by the BIOS (specified Disabled or automatic). Mode Sets the hardware to support SIR (Standard IR), ASK IR SIR (amplitude shift keyed IR), or FIR (Fast IR) infrared communications. (Driver installation required.) Base I/O address Sets the I/O address and interrupt. 2F8h, IRQ3 DMA channel For Fast IR mode, sets the DMA channel. DMA3 Parallel Port Sets how the parallel port is configured by the BIOS (specified Enabled or automatic).
Mode Sets the port to normal, bidirectional, EPP, or ECP. ECP Base I/O address Sets the I/O address. 378h Interrupt Sets the interrupt. IRQ7 DMA channel For ECP mode, sets the DMA channel. DMA3 OmniBook 900†: Sets how the audio system is configured by the BIOS Enabled Audio (specified or automatic). SB I/O address Sets the Sound Blaster I/O address. 220h WSS I/O address Sets the Windows Sound System I/O address. 530h AdLib I/O address Sets the AdLib synthesizer I/O address. 388h Interrupt Sets the interrupt. IRQ5 1st DMA channel Sets the DMA channel for playback. DMA1 2nd DMA channel Sets the DMA channel for recording.
DMA0 Security Menu Default User Password Is Shows if a user password is set. Clear Administrator Password Is Shows if an administrator password is set. Clear Set User Password Press ENTER to set, change, or clear user password. Password length can be no longer than 8 characters, 0-9, A-Z, and cannot include special or accented characters. Set Administrator Press ENTER to set, change, or clear administrator password. Password This password protects BIOS Setup settings. Password length can be no longer than 8 characters, 0-9, A-Z, and cannot include special or accented characters. Smart Card Security Available only if a smart card accessory is installed.
Sets Disabled whether the password is read from a smart card instead of entered from the keyboard. Boot Sets whether a password is required when the computer Enabled boots. Resume If boot security is enabled, sets whether a password is Enabled required when resuming from a suspended state. Undock If boot security is enabled, sets whether a password is Disabled required when undocking the OmniBook.