Types of screws This table describes the screws that are used in the product and provides guidelines to help determine where each type of screw is used. The screws can vary in length depending on the thickness of the material that is being fastened. Always note where each type of screw is located and replace each one in its original location. WARNING! Make sure that components are replaced with the correct screw type. Using the incorrect screw (for example, substituting a long screw for the correct shorter screw) can cause damage to the product or interfere with product operation.
Do not intermix screws that are removed with one component with the screws that are removed from another component. TIP: When you are disassembling the product, place the screws into the chassis holes from which they were removed. This prevents their loss, and ensures that the proper type and length of screw for each location is used when the product is reassembled. Table 2-1 Common fasteners used in this product Screw type Silver Torx head 4 x 10 mm screw with cone washer This screw type is shown in the following figure: ● Figure 2-31 Remove the flatbed scanner and ADF assembly (1 of 7) on page 39 12 Chapter 2 Removal and replacement ENWW