Hongqi — 空白页面

4-5. Use other driving system CAUTIONS  When the driver depresses the accelerator pedal to actively accelerate, the cruise speed icon displayed on the multi-function screen of the instrument cluster will flash. This is a normal phenomenon.  SACC may lose the target vehicle or misidentify the target vehicle when the vehicle enters or leaves a curve, changes lanes or the vehicle ahead is stationary.  Exercise greater caution to drive since the SACC cannot detect other sides, children, pedestrians, animals or other objects but rear of the vehicle or apply the brakes.

 Due to the SACC's limited braking capacity, there may be no time to deaccelerate to avoid collision with the preceding vehicle. This may happen when the preceding vehicle suddenly slows down, stops or enters your lane. In case of danger, press the brake pedal for braking actively.  Focus all of your attention on driving and get ready to take actions and to apply the brakes.  You need to adjust the safe interval and set the SACC system reasonably according to the front traffic volume and the current weather conditions (e.g., rain and snow). Whenever, you need to ensure that your vehicle can be decelerated to standstill within your field of vision.

 SACC can only identify the motor vehicles (such as cars and trucks) that are installed with legal license plates and allowed to travel on highways. If the preceding vehicle is irregular in shape, modified and/ or covered by painting, it may not be identified by the ACC, and the pedestrians and narrow vehicles (such as bicycles and motorcycles) may not be identified, either. In this case, you should get ready to control your vehicle according to the actual situation.  SACC system may not be able to accurately identify large trailers. At this time, the driver should take over the vehicle according to the actual situation.  SACC system cannot judge accurately the width of the front lane.

Therefore, when the front lane in the driving direction of the vehicle is too narrow and the driver feels unable to pass through it normally, the SACC system should be deactivated immediately by braking and the vehicle should be controlled by the driver.  Do not activate SACC on a long steep slope. SACC may not detect the preceding vehicle in the same lane on a long steep slope. You usually need to control the acceleration and braking of your vehicle by yourself on a long steep slope. If the brakes are applied, SACC is canceled.  The front vehicle symbol located on the instrument cluster will be displayed when vehicles traveling in the same direction on the same lane are detected.

If the symbol display is inconsistent with the actual situation observed by the driver, the driver is responsible for taking over the control and driving the vehicle according to the actual situation.  If you rest your foot on the accelerator pedal, SACC may not automatically apply the brakes, resulting in a collision with the preceding vehicle. In this case, exercise extreme caution. 162