4-5. Use other driving system ● Preconditions for starting the engine automatically The engine starts automatically if all the following conditions are met: • No-idling start/stop system corresponding fault. • The driver door is closed. • Engine compartment cover is closed. • Driver side seat belt is fastened. ● The engine starts again itself without your operation (one of the conditions is satisfied) • The brake vacuum is insufficient. • The battery status does not meet the conditions. CAUTIONS ■ When the idle start and stop system works ● Do not leave the vehicle when the ISSS stops the engine. Due to the automatic starting function of the engine, accidents may occur.
● When the vehicle is placed in a poorly ventilated place, do not stop the engine using the idle start-stop system. Due to the engine's automatic starting function, the engine may restart, causing the exhaust gas to gather and enter the vehicle, which may seriously endanger the health or even result in death. ● To ensure safety, it is necessary to ensure the door is closed, the driver's seat belt is fastened, the hood is closed and the steering wheel is returned to its normal position. Otherwise, idle start-stop cannot be activated, and automatic shut down or start cannot be realized.
● To prevent frequent start and stop of the vehicle under extreme congestion, the vehicle speed after shutdown needs to be more than 5km/h to activated automatic shut down or start again. ● In the idle stop status, if the system detects that the relevant conditions are not met, the engine may be started automatically even if the brake pedal is not trigged. ● In idle stop state, the driver performs operations such as unfastening the seat belt or opening the door, and the brake pedal is triggered. At this time, the instrument will prompt that the engine needs to be started manually.
At this time, the driver is required to resume these operations or start the vehicle manually through the engine switch. ■ To ensure the drivability, comfort and protection of various systems of the vehicle, there are many preconditions for starting and stopping idling, such as low battery power or temperature, unsuitable air conditioning system, low engine water temperature, too high altitude, uncomfortable or economical driving mode, too large gradient, too low brake vacuum degree, too high gearbox temperature, and relevant system faults, etc. All of which will prohibit automatic starting and stopping.
After vehicle braking, if the vehicle cannot be stopped due to the above conditions, the start-stop limitation symbol will be displayed on the meter. Therefore, it is not necessary to pay attention to whether or not to stop during driving. The idling start-stop system has integrated all aspects of drivability, safety and comfort to ensure all-round escort. 198