6.1. Using the A/C System ADS anti-fog sensor At the running state of air conditioner, when the windshield has a fogging tendency, A/C system will enter the automatic anti-fogging mode, and the air volume will be appropriately increased and blow towards the windshield; when the tendency is eliminated, A/C system will automatically switch back to the operating state before its anti-fogging control. After entering the automatic anti-fogging mode, you can exit the automatic anti-fogging mode by operating AUTO button or air outlet mode adjusting button. If the fogging tendency of windshield can’t be eliminated after a period of time, the system will restart the mode. Tips:
After entering the automatic defogging mode, A/C system will have a large air volume; in the event of heavy rain, rainstorm or other bad weather, in order to achieve rapid defogging effect, it’s recommended to start the forced defrosting/defogging function of windshield. Natural ventilation function Touch the natural ventilation button on the multimedia display to enter the natural ventilation mode, and its intake mode is switched to external circulation. At this time, the compressor stops working to save the energy.
Ion purification After touching the ion-purifying button on A/C operating interface of multimedia display, the button lights up, the ion purification function is turned on, the touch is turned on again, the button is turned off, and the ion purification function stops. 6 Interior Equipment The system has two purification modes, namely the sterilization operating mode and negative ion operating mode. The car switches automatically between these two modes during the operation of system. When the blower fails to work, the air purifier can’t work even if the air purifying function is activated.
PM2.5 sensor After touching [PM2.5] button on the multimedia display, the button lights up, and PM2.5 concentration of air inside the car is detected. When the detection is completed, if the concentration reaches the standard, the system will automatically exit;if not, the system will automatically start filtering and exit after the filtration is completed. Pres and hold the [PM2.5] button to turn on the PM2.5 filtering function. Hold [PM2.5] button to enable forced PM2.5 filtration function. 277