7-3. Maintenance for user ■ Power Management System When the battery runs down, some comfort functions may be limited and disabled to ensure vehicle startability. When the battery power is restored to the safe range, the above comfort type functions will be automatically restored to the user's set operating state to function. ■ Check the exterior of the battery Ensure that the battery terminals are not corroded, the connections are not loosened, the external parts are free of cracks, and the fixing clips are not loosened.
Positive Terminal Negative Terminal Fixing clamp ■ During installation When wiring the battery, prevent the terminal cables from being connected reversely, otherwise the electric equipment in the car may be damaged. During storage, transportation, and installation of the battery, prevent the positive and negative terminals from contacting. For example, the metal wrench of the wiring can easily touch the positive and negative terminals at the same time. In this case, the battery may be short-circuited and cause direct failure. Because the battery has a small exhaust hole, do not lay it sideways or upside down during storage, handling, and installation of the battery to prevent leakage.
When replacing the battery, replace the battery of the same model as the original one. When replacing the battery, if the wiring clip is oxidized or dirty, the oxide layer or dirt must be removed with sandpaper, etc. and then the wiring clip and battery terminal can be wired only after vaseline is applied. During installation, connect the positive terminal before connecting the negative terminal, and during disassembly, disconnect the negative terminal before disconnecting the positive terminal, to avoid short circuit danger. 322 Battery