en Basic settings 5. Press to start the operation. a The appliance starts to heat and the time starts to ‒ Press to switch the appliance off. The appliance automatically switches off after ap- prox. 10 to 20 minutes. count down. 6. Once the cooking time has elapsed, an audible sig- nal sounds. The cooking time is at zero. The appli- ance stops heating up and responds again as usual outside of Sabbath mode. 15 Basic settings You can configure the appliance to meet your needs.
Basic setting Selection Fan run-on time Recommended 1 15.1 Overview of the basic settings Minimum Pull-out system Not retrofitted (if shelf sup- ports and a single set of pull-out rails are fitted) 1 Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features of your appliance. Basic setting Selection Language See selection on the appli- ance. Clock Clock in 24-hour format.
Water hardness → "Before using for the first time", Page 11 Retrofitted (if two or three sets of pull-out rails are fit- ted) Sabbath mode Switched on Switched off 1 1 Factory setting (may vary according to model) 00 (softened) 01 (soft) 02 (med.) 03 (hard) 04 (very hard) 1 15.2 Changing the basic settings Requirement: The appliance is switched on. 1. Press . 2. Press "Basic settings". 3. Press the required basic setting and use the control Factory setting Reset Do not reset 1 Audible signal Short duration (30 seconds) Medium duration (1 minute) 1 ring to change it. The red bar next to the text field identifies the basic setting that is currently selected.
Its corresponding value is shown in the display. 4. Use "Further settings" to scroll through the basic Long duration (5 minutes) Volume 5 settings Button tone Switched on Switched off (tone remains for ) 1 settings and, if required, use the control ring to change any of these settings. 5. To save your changes, press and use "Save" to confirm. Note: Your changes to the basic settings will be re- tained even after a power failure. Display brightness 5 settings Clock display Off Digital 1 Analogue Lighting Off during operation On during operation 1 Discarding changes to the basic settings ▶ Press and use "Do not save" to confirm. a All changes will be discarded and not saved.
Operation after switch- on Main menu Types of heating 1 Steam Assist Night-time dimming Switched off 1 15.3 Setting the time Requirement: The appliance is switched on. 1. Press . 2. Press "Basic settings". 3. Press "Time". 4. Use the control ring to change the time. 5. To save your changes, press and use "Save" to confirm. Switched on Brand logo Display 1 Do not display 1 Factory setting (may vary according to model) 20