Quick Start EN 4.4.2 Battery replacement Batteries can be recharged, but they are easily consumable. If the standby time is greatly reduced, you need to replace the battery. The specification of the battery is 18650 lithium battery, 3.7V, 2600mA. Please refer to the following steps to replace: 1 Open the standing, you can see two screws. Remove the screws and remove the battery cover to see the battery. Figure 4.8 Open the stand 2 Take out the battery from the negative pole, and then take out the battery after the negative pole leaves. 3 When installing the battery, ensure that the positive terminal of the battery has HTM200 user manual Copyright Qingdao Hantek Electronics Co., LTD 20