Remote control and data transmission EN 6 Remote control and data transmission There are basically three ways to remotely control the instrument as followings: User defined programming Users can program to control the instrument using Standard Commands for Programmable Instruments (SCPI). For detailed instructions on commands and programming, refer to the Programming Manua l of the series. Use PC software or Android apps Users can use the PC software or Android applications of this series to remotely control the instrument. Network data transmission This product supports network data transmission.
Users can realize communication between the instrument and PC terminal or Android mobile terminal through 4G network module. The instrument supports communication with computer through USB interface, Bluetooth module and 4G network module. Remote control is based on the Standard Commands for Programmable Instruments (SCPI) command set. This chapter will introduce how to use the corresponding software to control the instrument remotely through various interfaces. Note: Before connecting the communication cable, shut down the device to avoid damaging the communication interface of the device. 6.1 Control via USB Press the power button to turn on the instrument.
Use the USB cable to connect the instrument to an Android phone or a Windows computer to carry out USB communication. HTM200 user manual Copyright Qingdao Hantek Electronics Co., LTD 30