Fuser assembly 1 Remove the left side cover (see “Left side cover” on page 81). 2 Remove the back cover (see “Back cover” on page 82). 3 Remove the right side cover (see “Right side cover” on page 84). 4 Remove the top cover (see “Top cover” on page 87). 5 Remove two screws (callout 1) from the right fuser plate. 6 Remove a third screw (callout 2) from behind the large gear on the right fuser plate. Note You can access the third screw through the holes in the 69Tgear. If you need to realign the 69T gear, you must first remove the pressure roller gear. Release the tab (callout 3) and remove the pressure roller gear from the printer. 7 Remove the bracket. 1 2 3 Figure 46.
Removing the fuser assembly (1 of 4) ENWW Internal assemblies 103