Table 18. Solving print image-quality problems (continued) Problem Cause Solution The printed page has a gray background. The priority input tray is not in place. Adjust the priority input tray. The print density setting is set too high. Decrease the amount of background shading through the device configuration utility. The media basis weight is too high. Change the media to a lower basis weight. The humidity level is too low. Very low humidity can increase the amount of background shading. Move the printer to a different location, or decrease the background shading through the device configuration utility. The print cartridge needs to be replaced. Replace the print cartridge.
Toner smears appear on the printed page. If the toner smears appear on the leading edge of the media, the media guides are dirty. Wipe the media guides with a dry, lint- free cloth. The media you are using does not meet HP’s specifications (for example, it is too moist or too rough). Make sure that the media meets specifications detailed in the Print Media Guide for the HP LaserJet printer family. The print cartridge needs to be replaced. Replace the print cartridge. The fuser temperature is too low. Select Optimize for: in the Paper tab of the printer driver. Make sure that it is set for the appropriate media. The toner is loose, and it does not stay attached to the printed page.
The inside of the printer is dirty. Clean the printer. (See “Cleaning the print path” on page 46.) The media you are using does not meet HP’s specifications (for example, it is too moist or too rough). Make sure that the media meets specifications detailed in the Print Media Guide for the HP LaserJet printer family. The print cartridge needs to be replaced. Replace the print cartridge. The printer driver is not set for the correct media. 1. Select Optimize for: in the Paper tab of the printer driver. Select the correct media. 2. Select the correct media through the device configuration utility. The power strip is not working correctly. Plug the printer directly into an AC outlet.
ENWW Errors 151