To print a continuous self-test page 1 Turn the printer off. 2 Press and hold the G O button. 3 Turn the printer on and continue to hold the G O button for approximately 15 seconds. Do not hold the G O button for more than 20 seconds, or you might initialize NVRAM. Note During this process the Attention LED will turn on. If the Ready LED also turns on before you release the G O button, you must start again with step 1. 4 Release the G O button, and the printer LEDs will begin cycling and will run until the printer is in the ready state. To stop a continuous self-test page Press the G O button. 168 Chapter 6 - Troubleshooting ENWW