Customizing and Verifying the MLD Protocol Customizing and Verifying MLD on an Interface To customize and verify MLD on an interface, perform this procedure: Procedure Implementing IPv6 Multicast Customizing and Verifying the MLD Protocol Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface type number Example: Device(config)# interface GigabitEthernet 1/0/1 Specifies an interface type and number, and places the switch in interface configuration mode.
Step 4 ipv6 mld join-group [group-address] [include | exclude] {source-address | source-list [acl]} Example: Device(config-if)# ipv6 mld join-group FF04::10 Configures MLD reporting for a specified group and source. Step 5 ipv6 mld access-group access-list-name Example: Device(config-if)# ipv6 access-list acc-grp-1 Allows the user to perform IPv6 multicast receiver access control. Step 6 ipv6 mld static-group [group-address] [include | exclude] {source-address | source-list [acl]} Example:
Device(config-if)# ipv6 mld static-group ff04::10 include 100::1 Statically forwards traffic for the multicast group onto a specified interface and cause the interface to behave as if a MLD joiner were present on the interface. Step 7 ipv6 mld query-max-response-time seconds Example: Configures the timeout value before the switch takes over as the querier for the interface. Implementing IPv6 Multicast 10