Clearing the PIM Topology Table to Reset the MRIB Connection No configuration is necessary to use the MRIB. However, users may in certain situations want to clear the PIM topology table in order to reset the MRIB connection and verify MRIB information. To clear the PIM topology table to reset the MRIB connection, perform this procedure: Procedure Implementing IPv6 Multicast Clearing the PIM Topology Table to Reset the MRIB Connection Command or Action Purpose Step 4 show ipv6 pim traffic Example: Device# show ipv6 pim traffic Displays the PIM traffic counters. Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 clear ipv6 pim topology [group-name | group-address] Example: Device# clear ipv6 pim topology FF04::10 Clears the PIM topology table. Step 4 show ipv6 mrib client [filter] [name {client-name | client-name : client-id}] Example: Device# show ipv6 mrib client Displays multicast-related information about an interface. Step 5 show ipv6 mrib route {link-local | summary | [sourceaddress-or-name | *] [groupname-or-address[ prefix-length]]] Example:
Device# show ipv6 mrib route Displays the MRIB route information. Implementing IPv6 Multicast 19