Monitoring IPv6 PIM Stub Routing Table 2: PIM Stub Configuration show Commands Configuring a BSR The tasks included here are described below. Configuring a BSR and Verifying BSR Information To configure and verify BSR Information, perform this procedure: Implementing IPv6 Multicast Monitoring IPv6 PIM Stub Routing Command or Action Purpose Step 5 ipv6 pim Example: Device(config-if)# ipv6 pim Enables the PIM on the interface. Step 6 ipv6 pim {bsr} | {dr-priority | value} | {hello-interval | seconds} | {join-prune-interval | seconds} | {passive} Example:
Device(config-if)# ipv6 pim bsr|dr-priority|hello-interval|join-prune-interval|passive Configures the various PIM stub features on the interface. Enter bsr to configure BSR on a PIM switch Enter dr-priority to configure the DR priority on a PIM switch. Enter hello-interval to configure the frequency of PIM hello messages on an interface. Enter join-prune-interval to configure periodic join and prune announcement intervals for a specified interface. Enter passive to configure the PIM in the passive mode. Step 7 end Example: Device(config-if)# end Returns to privileged EXEC mode. Command Purpose show ipv6 pim interface Displays the PIM stub that is enabled on each interface.
show ipv6 mld groups Displays the interested clients that have joined the specific multicast source group. show ipv6 mroute Verifies that the multicast stream forwards from the source to the interested clients. Implementing IPv6 Multicast 23