Creating a New Project As mentioned previously, normal users have too little privileges to properly run the OPC Client/Server module. Therefore, you must configure your user account to have those privileges: 1. Open the Component Services console ( Start > Control Panel > Administrative Tools > Component Services ). 2. In the console window, select the folder "Console Root\Component Services\Computers\My Computer \DCOM Config". Selecting the OPC Server module in the Component Services console 3. In the DCOM Config pane, right-click the Studio Scada OPC Server icon and then choose Properties from the shortcut menu. The Studio SCADA OPC Server propety sheet is displayed. 4.
Click the Identity tab. 5. Click This user and then complete the fields with the same user and password that you specified when you created the service. In this example, user is Studio and password is also Studio . 6. Click OK to apply your changes and close the property sheet. Entering the user name and password 7. Close the Component Services console. Troubleshooting When IWS runs under Windows services, it has no user interface. Therefore, if an error occurs, it will only be logged as a Windows application event. You can check the messages by using the Event Viewer console ( Start > Control Panel > Administrative Tools > Event Viewer ).
IWS error messages in the Event Viewer InduSoft Web Studio Page 103